GRINDING

Sinotech offers an exceptionally wide range of secondary processes that are applied to metals formed in hot or cold processes. Sinotech' Supplier Quality Engineers determine the availability of the process within the metal forming facility, as well as the quality. If the internal secondary processes do not meet Sinotech standards then the processes are carried out in Sinotech-audited and qualified off-site secondary processing facilities. Sinotech has audited, qualified and worked with QS-9000 and ISO certified secondary processing facilities in China for over 12 years. Sinotech is dedicated to managing your project on-site in China and delivering parts to you at lower prices but the same quality, service and terms as a domestic supplier.

Grinding is a finishing process used to improve surface finish, abrade hard materials, and tighten the tolerance on flat and cylindrical surfaces by removing a small amount of material. Information in this section is organized according to the subcategory links in the menu bar to the left.

In grinding, an abrasive material rubs against the metal part and removes tiny pieces of material. The abrasive material is typically on the surface of a wheel or belt and abrades material in a way similar to sanding. On a microscopic scale, the chip formation in grinding is the same as that found in other machining processes. The abrasive action of grinding generates excessive heat so that flooding of the cutting area with fluid is necessary.

Reasons for Grinding

Reasons for grinding are:

1. The material is too hard to be machined economically. (The material may have been hardened in order to produce a low-wear finish, such as that in a bearing raceway.)
2. Tolerances required preclude machining. Grinding can produce flatness tolerances of less than +/-0.0025 mm (+/-0.0001 in) on a 127 x 127 mm (5 x 5 in) steel surface if the surface is adequately supported.
3. Machining removes excessive material.